HP J6039C - JetDirect 200M Print Server User Manual page 162

Table 9.6 TCP/IP Configuration Information (2 of 3)
Message
DEFAULT GATEWAY:
CONFIG BY:
BOOTP SERVER:
or
DHCP SERVER:
or
RARP SERVER:
BOOTP/DHCP
SERVER:
TFTP SERVER:
ENWW
Description
The IP address of the gateway used when sending packets
off the local network. Only one default gateway may be
configured. During initialization, a temporary value 0.0.0.0
is displayed. If not provided, the IP address of the Jetdirect
print server is used.
NOT SPECIFIED indicates that a default gateway is not
configured.
Identifies how the HP Jetdirect print server obtained its
IP configuration:
BOOTP: automatic configuration via a BOOTP server.
BOOTP/TFTP: automatic configuration via a BOOTP
server and TFTP configuration file.
DHCP: automatic configuration via a DHCP server
DHCP/TFTP: automatic configuration via a DHCP server
and TFTP configuration file.
RARP: automatic configuration via the Reverse Address
Resolution Protocol.
USER SPECIFIED: manual configuration via Telnet, the
printer's control panel, HP Web JetAdmin, embedded web
server, or other method.
DEFAULT IP: the default IP address was assigned. This
address may not be a valid address for your network.
NOT CONFIGURED: The print server was not configured
with IP parameters. Verify that TCP/IP is enabled, or check
for error status.
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP
configuration. It specifies the IP address of the system that
responds to the HP Jetdirect print server's request for
automatic TCP/IP configuration over the network.
NOT SPECIFIED indicates that the configuration server's
IP address could not be determined or was set to zero in
the response packet.
Displayed during initialization while the HP Jetdirect print
server attempts to obtain its TCP/IP configuration from a
BOOTP or DHCP server. The temporary address
displayed is 0.0.0.0.
The IP address of the system where the TFTP
configuration file is located. During initialization, the
temporary address 0.0.0.0 is displayed.
NOT SPECIFIED indicates that a TFTP server has not
been not been set.
HP Jetdirect Configuration Page 15