Panel Sensor Pcb Assy - Brother MFC-P2000 - B/W Laser Printer Service Manual

3.12

Panel Sensor PCB ASSY

(1) Remove the main shield.
(2) Remove the M4x12 screw securing the
Main shield
Taptite, bind M4x12
Panel Sensor PCB ASSY
Note:


When reassembling the panel sensor PCB, ensure that you slide PCB A
underneath the main shield.


When reassembling the panel sensor PCB, ensure that you fit the PCB into hook B
and hook C first. Then fit the two bosses to the PCB and secure the screw.


Ensure that the three clamps fix the motor harness, panel harness and CIS harness
on the back of the main shield. Refer to the figure below;
Sensor Harness
Mini Clamp
R Motor Harness
Mini Clamp
CIS Harness CIS Harness
C
Fig. 3-31
Taptite, bind M4x12
Fig. 3-32
panel sensor PCB
A
B
Nylon Clamp
III-20
ASSY.
Main shield
Panel Sensor PCB ASSY
Main Shield