Brother MFC-P2000 - B/W Laser Printer Service Manual page 138

Printing a Test Sample Page
We recommend that you print a test page. Refer to the instructions below.
Note

 The following test page operation will be invalid after the machine has received any data
from your computer.

 The test sample page can be printed by using the "Test Print Mode" procedure in
of the On-line User's Guide.
Note
If the machine does not print a test sample page, see
Q & A" of the On-line Users Guide. If you are still unable to print a test sample page after
reviewing the information in the Users Guide, consult your dealer.
After printing the test sample page, you are ready to prepare your computer to work with the
machine. The software setup varies depending upon your computer and operating system.
Refer to the relevant following section:
Action 7-1: Installation from CD-ROM
Action 7-2: Prepare the Printer Driver and the Scanner Driver for the Machine
Action 7-3: Prepare DOS for the Machine from floppy disk
Press the control panel switch .
The machine will start printing a test
sample page.
Note
The machine can also print settings, fonts,
and hexadecimal values of received data.
For more information, see "Test Print
Mode" in Chapter 3
Guide.
"CHAPTER 7
- 9 -
Chapter 3
of the On-line User's
TROUBLESHOOTING,