Brother MFC-P2000 - B/W Laser Printer Service Manual page 198

USER'S GUIDE
Test Print Mode
Lamp Lit
Drum
Alarm
Ready
Data
3-4
The machine has the following test print mode. Follow these steps:
1. Make sure that the top cover is closed.
2. Hold down the switch and turn on the power switch. Keep the
switch depressed until the Drum lamp comes on.
The Drum lamp lights to indicate that the machine is in the test print
mode.
3. Press the switch again to execute the test print or hold down the
switch to select another option and release the switch to execute the
selected option.
The test print modes are listed below:
Choice
Test sample page
Print Config & Print
Fonts I
Factory Reset
Hex Dump Print
Function
The machine prints a test sample page.
The machine returns to the ready status after
printing.
The machine prints the current configuration of
the machine and a list of the internal fonts.
The machine returns to the ready status after
printing.
The machine is restored to the factory setting
and permanent fonts and macros are cleared.
The machine returns to the ready status after
printing.
The machine can print data as hexadecimal
values, so that you can check data errors and
problems. To exit from this mode, you have to
turn off the machine.