Brother MFC-P2000 - B/W Laser Printer Service Manual page 235

Printing
Question
The machine prints
unexpectedly or it prints
garbage.
The machine cannot print full
pages of a document. An error
message "PRINT OVERRUN"
occurs.
The machine cannot print full
pages of a document. A
"MEMORY FULL" error
message occurs.
The machine cannot print full
pages of a document. A
"MEMORY FULL" error
message occurs.
My headers or footers appear
when I view my document on
screen but do not show up
when I print them.
Recommendation


Turn the machine off and on again to reset the
machine.


Make sure your application software is correctly
set up to use this machine by checking the
machine settings in your application software.
Check the machine emulation settings. If you can use
the supplied RPC program, use it to change the
settings as required. Also, you can print the
current setting list from the RPC program or
Machine Control Panel.
The machine received a very complex print job and
could not process part of the page. This may be
solved by the following ways.


If you are using Windows 95 or Windows 3.1
with the supplied printer driver, see the "Setting
up the Machine for Windows" section.


Try to reduce the complexity of your document or
reduce the print resolution.


Reduce the graphic quality or the number of font
sizes within your application software.


Reduce the print resolution.


Reduce the complexity of your document and try
again.


Reduce the print resolution.


Reduce the complexity of your document and try
again.


Reduce the graphic quality or the number of font
sizes within your application software.
Most laser printerss have a restricted area that cannot
be printed on. Usually the first two lines and last two
lines of text cannot print (leaving 62 printable lines).
Adjust the top and bottom margins in your document
to allow for this.
CHAPTER 7 TROUBLESHOOTING
7-13