Brother MFC-P2000 - B/W Laser Printer Service Manual page 56

(3) Remove the two M3x12 tapping screws.
(4) Open the fixing unit cover along the open side of the fixing unit cover.
Taptite, bind M3x12
Fixing unit
v r
Pressure roller
(5) Release the right side of the paper eject roller shaft.
(6) Remove the four
frame. Then, remove the
Paper eject roller shaft
(7) Remove the M3x10 self tapping screw securing the connector plate.
(8) Remove the connector plate from the fixing unit frame and loosen the other M3x10
tapping screw securing the fixing unit cover.
(9) Remove the idle gear 16 from the fixing unit frame.
(10) Remove the heat roller gear, retaining ring,
bearing. Then, remove the
Caution :
Never touch the surface of the halogen heater lamp and the heat roller.
Fixing unit frame
Fig. 3-21
eject pinch rollers and the pinch springs from the fixing unit
pinch spring from each pinch roller.
Fig. 3-21a
halogen heater lamp
III-15
Fixing unit cover
Eject Pinch Roller
heat roller washer and
from the heat roller.
PR98292
Shaft
Pinch Spring
heat roller