I-6
Black and blurred vertical streaks
<Scanning>
Possible cause
Step
Stains on the
CIS window
Dirt on the
document
pressure bar
Scratch on the
document
pressure bar
<Printing>
Possible cause
Step
Corona failure
Corona failure
Dirt in the paper
feed system
Scratch on the
drum
Cleaning failure
Scratch on the
heat roller
Note:
If you print the same pattern continuously, the drum will be worn and black vertical
streaks will appear on the paper.
Check
1
Are there any stains on the
CIS window?
2
Is the document pressure bar
dirty?
3
Are there any scratches on the
document pressure bar?
Check
1
Is the corona wire dirty?
2
Is the vertical block streak
about 10 mm wide?
Is the corona wire cleaner not
in its home position?
3
Is the paper tray or feed
system on the drum unit soiled
with toner?
4
Is the drum surface scratched?
5
Is the drum surface dirty with
toner in streaks?
6
Is the surface of the heat roller
scratched?
Result
Yes
Yes
Yes
Result
Yes
Yes
Yes
Yes
Yes
Yes
IV-11
Remedy
Clean the CIS window.
Clean the document pressure
bar.
Replace the document
pressure bar.
Remedy
Clean the corona
wire with the wire
cleaner.
Return the wire
cleaner to its home
position.
Clean the toner off.
Replace the drum
unit.
Replace the drum
unit.
Replace the fixing
unit.
GND
contacts
(Fig.4-5)