Bl-1000; Bl-1001; Bl-1002; Bl System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

BL System Messages

BL-1000

Message
<timestamp>, [BL-1000], <sequence-number>,, INFO, <system-name>, Initializing
ports...
Probable Cause Indicates that the switch has started initializing the ports.
Recommended No action is required.
Action
Severity INFO

BL-1001

Message
<timestamp>, [BL-1001], <sequence-number>,, INFO, <system-name>, Port
initialization completed.
Probable Cause Indicates that the switch has completed initializing the ports.
Recommended No action is required.
Action
Severity INFO

BL-1002

Message
<timestamp>, [BL-1002], <sequence-number>, FFDC, CRITICAL, <system-name>, Init
Failed: slot <slot number> DISABLED because internal ports were not ONLINE, <list
of internal port number not ONLINE>.
Probable Cause Indicates that the blade initiation failed because one or more of the internal ports were not online.
The blade is faulted.
Recommended Make sure that the blade is seated correctly. If the blade is seated correctly, reboot or power cycle
Action the blade.
Run the systemVerification command to verify that the blade does not have hardware problems.
Note that any reference seen to slot 0 is a reference to the blade within the switch platform,
e.g.,Brocade 7500 and AP7600 contain FR4-18i and FA4-18 blades respectively.
Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric
OS Command Reference for more information on these command.
Fabric OS Message Reference
53-1000600-02
Chapter
5
47