Auth-1031; Auth-1032; Auth-1033 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Probable Cause Indicates the receiving payload does not have valid message code for a particular authentication
phase.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1031

Message
<timestamp>, [AUTH-1031], <sequence-number>,, ERROR, <system-name>, Failed to
retrieve secret value: port
Probable Cause Indicates that the secret value was not set properly for the authenticated entity.
Recommended Reset the secret value by using secAuthSecret command.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
Severity ERROR

AUTH-1032

Message
<timestamp>, [AUTH-1032], <sequence-number>,, ERROR, <system-name>, Failed to
generate <data type> for <message payload> payload: length <data length>, error
code <error code>, port <port number>.
Probable Cause Indicates that the authentication process failed to generate specific data (that is, challenge, nonce,
or response data) for an authentication payload. This usually relates to internal failure.
A nonce is a single-use, usually random value used in authentication protocols to prevent replay
attacks.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1033

Message
<timestamp>, [AUTH-1033], <sequence-number>,, ERROR, <system-name>, Disable port
<port number> due to unauthorized switch <switch WWN value>.
Fabric OS Message Reference
53-1000600-02
<port number>.
3
AUTH-1031
39