BM System Messages
BM-1001
Message
<timestamp>, [BM-1001], <sequence-number>,, ERROR, <system-name>, BM protocol
version <Protocol version> in slot <Slot number>.
Probable Cause
Indicates that the software running on the CP cannot communicate with the AP blade in the
indicated slot, in order to determine AP blade's firmware version. This can be due to one of the
following:
•
•
Recommended
The problem can be corrected by changing the firmware version on either the control processor
Action
(CP) or on the application processor (AP) blade. The firmware version on the CP blade can be
changed using the firmwareDownload command. Refer to the release notes to determine whether
a non-disruptive firmware download is supported between the versions. As the AP and CP blades
cannot communicate, it is not possible to load new firmware on the AP blade. If needed, send the
AP blade back to the factory for a firmware update.
Severity
ERROR
BM-1002
Message
<timestamp>, [BM-1002], <sequence-number>,, INFO, <system-name>, Connection
established between CP and blade in slot
Probable Cause
The control processor (CP) has established a connection to the blade processor (BP) and can
communicate.
Recommended
No action is required.
Action
Severity
INFO
BM-1003
Message
<timestamp>, [BM-1003], <sequence-number>,, WARNING, <system-name>, Failed to
establish connection between CP and blade in slot
Probable Cause
The control processor (CP) could not establish a connection to the blade processor (BP) to
communicate.
Fabric OS Message Reference
53-1000600-02
The CP blade is running a later version than the AP blade.
The CP blade is running a much older version than the AP blade.
<Slot number>.
<Slot number>
Chapter
7
. Faulting blade.
63