Bl-1003; Bl-1004; Bl-1006 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

5

BL-1003

Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled.
Additional blade fault messages precede and follow this error, providing more information. See
other error messages for recommended action.
If the message persists, replace the blade.
Severity CRITICAL
BL-1003
Message
<timestamp>, [BL-1003], <sequence-number>, FFDC, CRITICAL, <system-name>,
Faulting blade in slot
Probable Cause Indicates a faulty blade in the specified slot number.
Recommended Make sure that the blade is seated correctly. If the blade is seated correctly, reboot or power cycle
Action the blade.
Run the systemVerification command to verify that blade does not have hardware problems. Run
the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric OS
Command Reference for more information on these commands.
If the message persists, replace the blade.
Severity CRITICAL

BL-1004

Message
<timestamp>, [BL-1004], <sequence-number>, FFDC, CRITICAL, <system-name>,
Suppressing blade fault in slot
Probable Cause Indicates that the specified blade experienced a failure but was not faulted due to a user setting.
Recommended Reboot or power cycle the blade, using the slotPowerOff and slotPowerOn commands.
Action
Run the systemVerification command to verify that the blade does not have hardware problems.
Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric
OS Command Reference for more information on these commands.
If the message persists, replace the blade.
Severity CRITICAL

BL-1006

Message
<timestamp>, [BL-1006], <sequence-number>,, INFO, <system-name>, Blade <slot
number> NOT faulted. Peer blade <slot number> experienced abrupt failure.
48
<slot number>.
<slot number>.
Fabric OS Message Reference
53-1000600-02