Auth-1034; Auth-1035; Auth-1036 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

3

AUTH-1034

Probable Cause Indicates that an entity was not configured in the switch connection control (SCC) policy and tried
to connect to the port.
Recommended Add the entity's world-wide name (WWN) to the SCC policy and reinitialize authentication by using
Action the portDisable and portEnable commands or the switchDisable and switchEnable commands.
Severity ERROR
AUTH-1034
Message
<timestamp>, [AUTH-1034], <sequence-number>,, ERROR, <system-name>, Failed to
validate name <entity name> in <authentication message>: port <port number>.
Probable Cause Indicates that the specified entity name in the payload is not in the correct format.
Recommended Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
Action and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1035

Message
<timestamp>, [AUTH-1035], <sequence-number>,, ERROR, <system-name>, Invalid <data
type> length in <message phase> message: length <data length>, port <port number>.
Probable Cause Indicates that a particular data field in the authentication message has an invalid length field. This
error usually relates to internal failure.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1036

Message
<timestamp>, [AUTH-1036], <sequence-number>,, ERROR, <system-name>, Invalid state
<state value> for <authentication phase>: port <port number>.
Probable Cause Indicates that the switch received an unexpected authentication message.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
40 Fabric OS Message Reference
53-1000600-02