Bl-1027; Bl-1028; Bl-1029 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

5

BL-1027

Recommended Collect supportSave information, then reboot switch and run the diagPost command to ensure
Action Power-On Self-Test (POST) is enabled. If problem persists, replace switch.
Severity CRITICAL
BL-1027
Message
<timestamp>, [BL-1027], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <slot number> faulted, boot failed; status 0x<boot status> 0x<1250 0 boot
status> 0x<1250 1 boot status>.
Probable Cause Indicates that the blade failed to boot properly.
Recommended Reboot or power cycle the blade.
Action
If the message persists, replace the blade.
Severity CRITICAL

BL-1028

Message
<timestamp>, [BL-1028], <sequence-number>,, CRITICAL, <system-name>, Switch
faulted; internal processor was reset before switch init completed.
Probable Cause Indicates that the switch's internal processor was reset before the initialization completed.
Recommended Reboot or power cycle the switch.
Action
If the message persists, replace the switch.
Severity CRITICAL

BL-1029

Message
<timestamp>, [BL-1029], <sequence-number>,, INFO, <system-name>, All ports on the
switch will be reset as part of the firmware upgrade.
Probable Cause Indicates that a recent firmware upgrade caused the switch's internal processor firmware to be
upgraded and resulted in the cold upgrade. As part of the upgrade, all the datapath elements were
reset.
Recommended No action is required.
Action
Severity INFO
56 Fabric OS Message Reference
53-1000600-02