Auth-1037; Auth-1038; Auth-1039 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1037

Message
<timestamp>, [AUTH-1037], <sequence-number>,, ERROR, <system-name>, Failed to
<operation type> response for <authentication message>: init_len <data length>,
resp_len <data length>, port <port number>.
Probable Cause Indicates that a Diffie Hellman - challenge handshake authentication protocol (DH-CHAP)
authentication operation failed on the specified port due to mismatched response values between
two entities.
Recommended The error might indicate that an invalid entity tried to connect to the switch. Check the connection
Action port for a possible security attack.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1038

Message
<timestamp>, [AUTH-1038], <sequence-number>,, ERROR, <system-name>, Failed to
retrieve certificate during <authentication phase>: port <port number>.
Probable Cause Indicates that the public key infrastructure (PKI) certificate is not installed properly.
Recommended Reinstall the PKI certificate, using the pkiCreate command.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1039

Message
<timestamp>, [AUTH-1039], <sequence-number>,, ERROR, <system-name>, Neighboring
switch has conflicting authentication policy: Port <Port Number> disabled.
Probable Cause Indicates that the neighboring switch has a conflicting authentication policy enabled. The_E-Port
has been disabled, because the neighboring switch rejected the authentication negotiation, and
the local switch has a strict switch authentication policy.
Fabric OS Message Reference
53-1000600-02
3
AUTH-1037
41