Auth-1012; Auth-1013; Auth-1014; Auth-1016 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

3

AUTH-1012

AUTH-1012
Message
<timestamp>, [AUTH-1012], <sequence-number>,, WARNING, <system-name>,
Authentication <code> is rejected: port <port number> explain <explain code>
reason <reason code>.
Probable Cause Indicates that an authentication is rejected because the remote entity does not support
authentication.
Recommended Make sure the entity at the other end of the link supports authentication.
Action
Severity WARNING

AUTH-1013

Message
<timestamp>, [AUTH-1013], <sequence-number>,, WARNING, <system-name>, Can not
perform authentication request message: port <port number>, message code <message
code>.
Probable Cause Indicates that the system is running low on resources when receiving an authentication request.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

AUTH-1014

Message
<timestamp>, [AUTH-1014], <sequence-number>, FFDC, ERROR, <system-name>, Invalid
port value to <operation>: port <port number>.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
Action and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1016

Message
<timestamp>, [AUTH-1016], <sequence-number>, FFDC, ERROR, <system-name>, Invalid
value to start HBA authentication port: <port number>, <pid>.
34 Fabric OS Message Reference
53-1000600-02