Auth-1025; Auth-1026; Auth-1027 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Severity ERROR

AUTH-1025

Message
<timestamp>, [AUTH-1025], <sequence-number>,, ERROR, <system-name>, Failed to get
<data type> during <authentication phase>: port <port number>.
Probable Cause Indicates that the authentication process failed to get the expected information during the
specified authentication phase.
Recommended Usually this problem is transient. The authentication might fail.
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

AUTH-1026

Message
<timestamp>, [AUTH-1026], <sequence-number>,, WARNING, <system-name>, Failed to
get <Device information> during negotiation phase: port <port number>.
Probable Cause Indicates that the authentication failed to get device or host bus adaptor (HBA) information due to
an internal failure.
Recommended Usually this problem is transient. If the authentication failed, retry the login.
Action
Reinitialize authentication using the switchDisable and switchEnable commands or the portDisable
and portEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

AUTH-1027

Message
<timestamp>, [AUTH-1027], <sequence-number>,, ERROR, <system-name>, Failed to
select <authentication value> during <authentication phase>: value <value> port
<port number>.
Probable Cause Indicates that the authentication process failed to select an authentication value (that is, DH
Group, hash value, or protocol type) from a receiving payload for the specified authentication
phase. This indicates that the local switch does not support the specified authentication value.
Recommended Check the authentication configuration and reset the supported value if needed using the authUtil
Action command.
Fabric OS Message Reference
53-1000600-02
3
AUTH-1025
37