Installing And Removing An Ethernet Switch Module; Installing An Ethernet Switch Module - Intel MFSYS25 - AXXPSU 1000W Power Supply Module User Manual

Installing and Removing an Ethernet Switch Module

The Intel
module pre-installed. Optionally, a second switch module may be installed in the second
switch module bay. An ethernet switch module can only be installed in a module bay that
is designed to support that device type. The two bays located immediately to the left and
right of the Management Module are dedicated to the Ethernet Switch Modules and are
labeled ESM. For the exact location of the switch module bay, see
The Ethernet switch module may be removed and installed using the steps detailed in the
following sections:
•
"Installing an Ethernet Switch Module" on page 23
•
"Removing an Ethernet Switch Module" on page 24

Installing an Ethernet Switch Module

To install an ethernet switch module, follow these steps:
1. Review the safety and ESD information at the beginning of this manual and in the
appendices.
2. Locate an available switch bay and remove any installed module or filler panel.
3. Release and rotate the module retention lever out and away from the switch module
(see letter "A" in
4. Slide the switch module into the selected module bay (see letter "B" in
until the bottom of the retention lever engages the bay.
®
Intel Modular Server System User Guide
®
Modular Server System MFSYS25/MFSYS35 ships with one Ethernet switch
Figure 12).
Figure 5.
Figure 12)
23