Table of Contents
Advertisement
CHAPTER 14
Performing Initial Software Configuration
on the J-SRX240 Services Gateway
J-SRX240 Services Gateway Software Configuration Overview
Preparing J-SRX240 Services Gateway for Configuration
This chapter includes the following topics:
J-SRX240 Services Gateway Software Configuration Overview on page 71
Performing Initial Software Configuration on the J-SRX240 Services Gateway Using
the CLI on page 74
Performing Initial Software Configuration on the J-SRX240 Services Gateway Using
the J-Web Interface on page 76
J-SRX240 Services Gateway Secure Web Access Overview on page 82
This topic includes the following sections:
Preparing J-SRX240 Services Gateway for Configuration on page 71
Understanding Built-In Ethernet Ports on page 72
Mapping the Chassis Cluster Ports on page 72
Understanding Management Access on page 73
The services gateway is shipped with the JUNOS Software preinstalled and ready to be
configured when the device is powered on.
When the device boots, it first attempts to start the image on the USB flash drive. If a
USB flash drive is not inserted into the Routing Engine or the attempt otherwise fails, the
device next tries the CompactFlash card (if installed), and finally the hard disk.
You configure the services gateway by issuing JUNOS command-line interface (CLI)
commands.
Gather the following information before configuring the device:
Device name to be used on the network
Domain name the device will use
71
Advertisement
Table of Contents
