Gateway; Connecting To The Cli At The User End For The J-Srx240 Services Gateway - Dell PowerConnect J-SRX240 Hardware Manual

Powerconnect j-series services gateway
Hide thumbs Also See for PowerConnect J-SRX240:
Table of Contents

Advertisement

Related Topics
Connecting the Modem to the Console Port on the J-SRX240 Services Gateway
Related Topics

Connecting to the CLI at the User End for the J-SRX240 Services Gateway

Chapter 13: Connecting the J-SRX240 Services Gateway to Management Devices
Connecting the J-SRX240 Services Gateway to the J-Web Interface on page 63
Connecting the J-SRX240 Services Gateway to the CLI on page 66
Connecting to the CLI at the User End for the J-SRX240 Services Gateway on page 69
Connecting the Modem to the Console Port on the J-SRX240 Services Gateway on
page 69
To connect the dial-up modem to the console port on the services gateway:
Turn off power to the services gateway.
1.
Turn off power to the modem.
2.
Plug one end of the Ethernet cable supplied with your services gateway into the
3.
console port (Figure 17 on page 129 shows the console cable connector) on the services

gateway.

Plug the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter
4.
supplied with your services gateway.
Connect the serial port adapter to a separately purchased DB-9 female to DB-25
5.
male adapter or other adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
6.
Connect the modem to your telephone network.
7.
Turn on the power to the modem.
8.
Power on the services gateway by pressing the Power button on the front panel.
9.
Verify that the
Power
NOTE: Most modems have an RS-232 DB-25 connector. You must separately purchase
an adapter to connect your modem to the RJ-45 to DB-9 adapter and Ethernet cable
supplied with the services gateway.
Connecting the J-SRX240 Services Gateway to the J-Web Interface on page 63
Connecting the J-SRX240 Services Gateway to the CLI on page 66
Connecting the Modem at the J-SRX240 Services Gateway End on page 68
Connecting to the CLI at the User End for the J-SRX240 Services Gateway on page 69
To remotely connect to the CLI through a dial-up modem connected to the console port
on the services gateway:
LED on the front panel turns green.
69

Advertisement

Table of Contents
loading

Table of Contents