NOTE: You must manually configure the IP address for the management port you are
using before you save your initial configuration. When you save the configuration for
the first time, you will lose the connection to the services gateway if you have not
manually configured the IP address. If you lose the connection through the management
interface, you must connect through the Console port.
Related Topics
Connecting the J-SRX240 Services Gateway to the CLI on page 66
Connecting to the CLI at the User End for the J-SRX240 Services Gateway on page 69
Connecting the Modem at the J-SRX240 Services Gateway End on page 68
Connecting the Modem to the Console Port on the J-SRX240 Services Gateway on
page 69
Chapter 13: Connecting the J-SRX240 Services Gateway to Management Devices
65