Gateway - Dell PowerConnect J-SRX240 Hardware Manual

PowerConnect J-SRX240 Services Gateway Hardware Guide
Related Topics
Connecting and Organizing Interface Cables to the J-SRX240 Services Gateway
56
To connect the device to the power supply:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the other end of the ESD strap to the ESD point on the rack.
Insert the appliance coupler end of a power cord into the appliance inlet on the power
2.
supply faceplate.
Insert the plug into an AC power source receptacle.
3.
NOTE: The device must be connected to earth ground during normal operation. The
protective earthing terminal on the rear of the chassis is provided to connect the device
to ground.
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on to the power supply point.
Installing the J-SRX240 Services Gateway on page 52
Required Tools and Parts for Installing and Maintaining the J-SRX240 Services Gateway
on page 45
Connecting and Organizing Interface Cables to the J-SRX240 Services Gateway on
page 56
Grounding the J-SRX240 Services Gateway on page 57
Powering On and Powering Off the J-SRX240 Services Gateway on page 59
Connecting the Interface Cables
You connect the interfaces installed in the services gateway to various network media.
Each type of interface on a services gateway uses a particular medium to transmit data.
You must configure each network interface before it can operate on the device.
To connect the interface cable to the device:
Have ready a length of the type of cable used by the interface.
1.
Insert the cable connector into the cable connector port on the interface faceplate.
2.
NOTE: External devices can be attached to console, Ethernet, or Gigabit Ethernet ports.
Organizing the Interface Cables