Setting Up Your Dell Edge Gateway - Dell 5000 Series Installation And Operation Manual

Setting up your Dell Edge
WARNING: Before you begin any of the procedures in this section, read the
safety information that shipped with your system. For additional best
practices information, go to www.dell.com/regulatory_compliance.
WARNING: When installing the Gateway, the responsible party or integrator
shall use the AC Adapter provided with the Dell Edge Gateway, or connect to a
24Vac or 24Vdc power source already present as part of the clients
installation.
WARNING: The Dell AC Adapter (full-wave rectified and have no built-in
isolation transformer) is acceptable for use up to ambient temperature of
40°C and is a limited power source, SELV/Limited Energy Circuit, Class 2
power source. If ambient temperature of the installation exceeds 40 °C then
use the 24Vac or 24Vdc power available as part of the installation.
WARNING: Always make sure that the available power source matches the
required input power of the Dell Edge Gateway, check the input power
markings next to power connector(s) before making connections. The 24 V
power source must be compliant with local Electrical Codes and Regulations.
WARNING: To ensure the protection provided by Dell Edge Gateway is not
impaired, do not use or install the system in any manner other than that which
is specified in this manual.
WARNING: When installing the Gateway use acable appropriate for the load
currents: 3-core cable rated 5 A at 90 °C (194 °F) minimum, which conform to
either IEC 60227 or IEC 60245. The system accepts cables from 0.8 to 2.5 mm
(18 to 14 AWG).
WARNING: The symbol
can obtain temperature during normal use that can cause a burn. Allow
equipment to cool off or use protective gloves when handling to reduce risk
of a burn.
WARNING: If a battery is included as part of System/Network, battery must be
must be installed with appropriate enclosure in accordance with local Fire and
Electrical Codes and Laws.
indicates hot surface or adjacent hot surface that

Setting up your Dell Edge Gateway

3
Gateway
10