Table of Contents
Advertisement
CHAPTER 12
J-SRX240 Services Gateway
Autoinstallation
J-SRX240 Services Gateway Autoinstallation Overview
Related Topics
This chapter includes the following topic:
J-SRX240 Services Gateway Autoinstallation Overview on page 61
The autoinstallation process begins any time a services gateway is powered on and
cannot locate a valid configuration file in the internal flash. Typically, a configuration file
is unavailable when a services gateway is powered on for the first time or if the
configuration file is deleted from the internal flash. The autoinstallation feature enables
you to deploy multiple services gateways from a central location in the network.
If you are setting up many devices, autoinstallation can help automate the configuration
process by loading configuration files onto new or existing devices automatically over
the network. You can use either the J-Web configuration editor or the CLI configuration
editor to configure a device for autoinstallation.
For the autoinstallation process to work, you must store one or more host-specific or
default configuration files on a configuration server in the network and have a service
available—typically Dynamic Host Configuration Protocol (DHCP)—to assign an IP address
to the services gateway.
Autoinstallation takes place automatically when you connect an Ethernet port on a new
services gateway to the network and power on the device. To simplify the process, you
can explicitly enable autoinstallation on a device and specify a configuration server, an
autoinstallation interface, and a protocol for IP address acquisition.
For more information about configuring autoinstallation, see the JUNOS Software
Administration Guide.
Connecting the J-SRX240 Services Gateway to the Power Supply on page 55
Grounding the J-SRX240 Services Gateway on page 57
Powering On and Powering Off the J-SRX240 Services Gateway on page 59
61
Advertisement
Table of Contents
