Connecting The J-Srx240 Services Gateway To The Cli - Dell PowerConnect J-SRX240 Hardware Manual

PowerConnect J-SRX240 Services Gateway Hardware Guide

Connecting the J-SRX240 Services Gateway to the CLI

66
If you plan to use the CLI to configure the J-SRX240 Services Gateway, you must connect
through the console port as shown in Figure 14 on page 66.
Figure 14: Connecting a J-SRX240 Services Gateway to the CLI
NOTE: The above figure shows a connection to a local management device. A remote
connection to the services gateway through a modem requires the cable and connector
shown (provided in the services gateway accessory box), plus a DB-9 female to DB-25
male (or similar) adapter for your modem, which you must purchase separately.
Connecting the Services Gateway to the CLI Locally
To connect to the CLI using a local management device through the console port on the
services gateway:
Turn off power to the services gateway.
1.
Turn off power to the management device, such as a PC or laptop computer, that
2.
you are using to access the CLI.
Plug one end of the Ethernet cable supplied with your services gateway into the
3.
RJ-45 to DB-9 serial port adapter supplied with your services gateway.
Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
4.
device.