Table of Contents
Advertisement
Related Topics
Changing the Reset Config Button Behavior on the J-SRX240 Services Gateway
Related Topics
To press the Reset Config button, insert a small probe (such as a straightened paper
clip) into the pinhole on the front panel.
By default, pressing and quickly releasing the Reset Config button loads and commits
the rescue configuration through the J-Web interface or the CLI. The Status LED glows
amber during this time. For details, see the JUNOS Software CLI User Guide.
By default, pressing and holding the Reset Config button for 15 seconds or more—until
the Status LED glows amber—deletes all configurations on the device, including the
backup configurations and rescue configuration, and loads and commits the factory
configuration. For details about factory default settings, see the JUNOS Software
Administration Guide.
Changing the Reset Config Button Behavior on the J-SRX240 Services Gateway on
page 95
Monitoring the J-SRX240 Services Gateway Chassis Using the CLI on page 87
Monitoring the J-SRX240 Services Gateway Components Using LEDs on page 89
J-SRX240 Services Gateway LEDs on page 14
You can change the default operation of the Reset Config button by limiting how the
button resets the services gateway:
To prevent the Reset Config button from setting the device to the factory default
configuration and deleting all other configurations, enter the following command:
user@host# set chassis config-button no-clear
You can still press and quickly release the button to reset it to the rescue configuration.
To prevent the Reset Config button from setting the device to the rescue configuration,
enter the following command:
user@host# set chassis config-button no-rescue
You can still press and hold the button for 15 seconds or more to reset the gateway to
the factory defaults.
To disable the button and prevent the device from resetting to either configuration,
use the following command:
user@host# set chassis config-button no-clear no-rescue
The
option prevents the Reset Config button from loading the rescue
no-rescue
configuration. The
no-clear
configurations on the services gateway.
To return the function of the Reset Config button to its default behavior, remove the
statement from the device configuration.
config-button
Monitoring the J-SRX240 Services Gateway Chassis Using the CLI on page 87
Chapter 16: Monitoring the J-SRX240 Services Gateway
option prevents the Reset Config button from deleting all
95
Advertisement
Table of Contents
