Monitoring The J-Srx240 Services Gateway Components Using Leds - Dell PowerConnect J-SRX240 Hardware Manual

Related Topics

Monitoring the J-SRX240 Services Gateway Components Using LEDs

Table 33: Component LEDs on the J-SRX240 Services Gateway
LED State
Status LED Green
Amber
Red
Alarm LED Red
Amber
Off
user@host > show chassis alarms
No alarms currently active
For more information, see the JUNOS Software Administration Guide.
Monitoring the J-SRX240 Services Gateway Components Using LEDs on page 89
Monitoring the J-SRX240 Services Gateway Using Chassis Alarm Conditions on page 92
Monitoring the J-SRX240 Services Gateway Power System on page 93
The LEDs available on the services gateway display the status of various components.
Table 33 on page 89 describes the LEDs.
Meaning
The device is functioning normally.
The device is starting up.
The Reset Config button is pressed.
An error is detected in the device.
The device detects a major alarm.
Indicates a minor alarm.
NOTE: The Alarm LED glows Amber
while initializing.
The device is starting up.
NOTE: When the system is up and
running, if the Alarm LED is off, it
indicates that no alarms are present
on the device.
Chapter 16: Monitoring the J-SRX240 Services Gateway
Possible Causes and Corrective
Actions
Normal condition. No action is
required.
Normal condition. No action is
required.
Contact Dell Support. See "Dell
Support" on page 96.
A major alarm indicates a critical
situation on the gateway that
requires immediate action. See A
"Monitoring the J-SRX240 Services
Gateway Using Chassis Alarm
Conditions" on page 92.
A minor alarm requires monitoring or
maintenance. If left unchecked, it
might cause an interruption in service
or degradation in performance. See
"Monitoring the J-SRX240 Services
Gateway Using Chassis Alarm
Conditions" on page 92.
Normal condition. No action is
required.
89