Monitoring The J-Srx100 Services Gateway Components Using Leds - Dell PowerConnect J-SRX100 Hardware Manual

Related
Documentation

Monitoring the J-SRX100 Services Gateway Components Using LEDs

Item
Chassis
J-SRX100S
Routing Engine
RE-SRX100-HM
da0 999 MB
usb0 <addr 1>
usb0 <addr 2>
usb0 <addr 3>
FPC 0
PIC 0
PIC
Power Supply 0
NOTE: The values given in the
debugging. This information is about USB hub topology.
Monitoring the J-SRX100 Services Gateway Components Using LEDs on page 89
Monitoring the J-SRX100 Services Gateway Using Chassis Alarm Conditions on page 91
Monitoring the J-SRX100 Services Gateway Power System on page 92
Maintaining the J-SRX100 Services Gateway Hardware Components on page 85
Using the Reset Config Button on the J-SRX100 Services Gateway on page 93
Dell Support on page 95
Table 30 on page 89 describes the status of the LEDs on startup of the device.
Table 30: Services Gateway LED Status on Startup
LED
Status LED
Alarm LED
Chapter 15: Monitoring the J-SRX100 Services Gateway
Version Part number
REV 00 750-02177
ST72682
DWC OTG root hub 0 vendor 0x0000
product 0x005a 90 vendor 0x0409
ST72682 High Speed Mode 64218 STMicroelectronics umass0
usb0 rows provide information for USB level
State
Amber
Amber
Serial number Description
AU0809AF0003
BAAA0116
Nand Flash
uhub0
uhub1
8x FE Base
Description
Indicates that the device is starting up.
Indicates that the device is starting up
for the first time since no rescue
configuration is set.
NOTE: When the system is up and
running, if the Alarm LED is off, it
indicates that no alarms are present on
the device.
Dell
FPC
89