Table of Contents
Advertisement
PowerConnect J-SRX210 Services Gateway Hardware Guide
Replacing or Installing Mini-Physical Interface Modules in the J-SRX210 Services
Gateway
Related Topics
74
Mini-Physical Interface Modules (Mini-PIMs) are circuit boards that you can install in a
device for enhanced functionality based on your requirements. They enable you to easily
add or change physical interfaces on a device.
The Mini-Physical Interface Module (Mini-PIM) slot is covered with a blank faceplate to
maintain proper airflow through the services gateway. Before installing the Mini-PIM, you
must remove the faceplate.
See the J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware
Guide for information about installing the Mini-PIMs.
NOTE: The Mini-PIMs available on the J-SRX210 Services Gateway are not
hot-swappable. You need to power off the device before removing or installing Mini-PIMs.
J-SRX210 Services Gateway Installation Safety Guidelines and Warnings on page 125
Installing the J-SRX210 Services Gateway on a Desk on page 70
Installing the J-SRX210 Services Gateway on a Wall on page 72
Installing the J-SRX210 Services Gateway in a Rack on page 67
Advertisement
Table of Contents
