Table of Contents
Advertisement
PowerConnect J-SRX210 Services Gateway Hardware Guide
Related Topics
J-SRX210 Services Gateway Agency Approvals
138
General Electrical Safety Guidelines and Warnings
Install the services gateway in compliance with the following local, national, or
international electrical codes:
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code
Canada—Canadian Electrical Code, Part 1, CSA C22.1
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
Evaluated to the TN power system
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
Carefully look for possible hazards in your work area, such as moist floors, ungrounded
power extension cords, and missing safety grounds.
Operate the services gateway within marked electrical ratings and product usage
instructions.
For the services gateway and peripheral equipment to function safely and correctly,
use the cables and connectors specified for the attached peripheral equipment, and
make certain they are in good condition.
J-SRX210 Services Gateway Electrical and Power Requirements on page 51
J-SRX210 Services Gateway Maintenance and Operational Safety Guidelines and
Warnings on page 133
J-SRX210 Services Gateway Agency Approvals on page 138
Grounding the J-SRX210 Services Gateway on page 77
The J-SRX210 Services Gateway complies with the following standards:
Safety
CSA 60950-1 (2003) Safety of Information Technology Equipment
UL 60950-1 (2003) Safety of Information Technology Equipment
EN 60950-1 (2001) Safety of Information Technology Equipment
IEC 60950-1 (2001) Safety of Information Technology Equipment (with country
deviations)
Advertisement
Table of Contents
