Table of Contents
Advertisement
Related Topics
Installing the J-SRX210 Services Gateway in a Rack
Figure 13 on page 67 shows the adjustments to the power supply adapter tray required
for the 150-watt power supply.
Figure 13: Adjusting Power Supply Adapter Tray for 150 Watts
Attaching the adapter stopper brackets into power supply adapter tray.
1.
Fully configured power supply adapter tray.
2.
Preparing the J-SRX210 Services Gateway for Rack-Mount, Desk-Mount, and
Wall-Mount Installation on page 61
Preparing the J-SRX210 Services Gateway for Rack-Mount Installation on page 62
You can front-mount the J-SRX210 Services Gateway in a rack. Many types of racks are
acceptable, including four-post (telco) racks, enclosed cabinets, and open-frame racks.
For more information about the type of rack or cabinet the J-SRX210 Services Gateway
can be installed into, see "J-SRX210 Services Gateway Rack Requirements" on page 49.
NOTE: The rack-mounting kit is not shipped with the device and must be ordered
separately.
NOTE:
If you are installing multiple devices in one rack, install the lowest one first and proceed
upward in the rack.
Make sure that the rubber feet from the base of the chassis are removed for rack
installation.
Chapter 12: Installing the J-SRX210 Services Gateway
67
Advertisement
Table of Contents
