Dell PowerConnect J-SRX210 Hardware Manual page 116

PowerConnect J-SRX210 Services Gateway Hardware Guide
100
Click Commit to apply the configuration and other pending changes (if any) and
click Discard to discard pending changes.
Configure an interface as follows:
3.
In the J-Web interface, select Configure>Interfaces
a.
The Interfaces page appears and lists the network interfaces present on the
services gateway.
Under the Interface Name column, click the interface you want to configure (for
b.
example ge-0/0/0).
Under Logical Interfaces, click Add.
c.
Under IPv4 Addresses and Prefixes, click Add.
d.
In the IPv4 Address and Prefix fields, enter an IP address and a subnet mask
e.
Click OK. The configured IP address is included in the Address Prefix column.
f.
Configure the default route as follows
4.
In the J-Web interface, select Configure>Routing>Static routing
a.
In the Static Routing page, click Add.
b.
Add an IP address for Route and Next-hop.
c.
Click OK. The configured IP address is included in the Static Routing page.
d.
Configure basic security zones and bind them to traffic interfaces.
5.
In the J-Web interface, under the Configure tab, navigate to Security > Zones
a.
Under Security Zone, click Add.
b.
Enter a name for the zone in the Zone Name field.
c.
Scroll down to the Interfaces Configuration panel on the page to add an interface
d.
to a specific zone.
Click OK to save the configuration.
e.
Configure basic security policies.
6.
In the J-Web interface, under the Configure tab, navigate to Security > Policy.
a.
In the Security Policy page, click Add.
b.
Enter a name for the policy and select the source and destination zones.
c.
Enter a source address, destination address, and an application.
d.
Select Policy Action as
e.
Click OK to save the configuration.
f.
, or , or .
Permit Deny Reject