Dell PowerConnect J-SRX210 Hardware Manual page 100

PowerConnect J-SRX210 Services Gateway Hardware Guide
84
Figure 24: Connecting to the Ethernet Port on a J-SRX210 Services
Gateway
To connect to the Ethernet port:
From the management device you use to access the J-Web interface (such as a PC
1.
or a laptop), verify that the address of the port you connect to is set to one of the
following values:
Ethernet address on the
Ethernet address from a DHCP server
Plug one end of the Ethernet cable into the Ethernet port on the management device.
2.
Connect the other end of the Ethernet cable to the built-in Gigabit Ethernet port on
3.
the services gateway.
Wait until the Status LED on the front panel turns solid green.
4.
Turn on the power to the management device. The services gateway assigns an IP
5.
address to the management device within the
services gateway is configured to use DHCP.
From the management device, open a Web browser and enter the IP address
6.
192.168.1.1 in the address field.
Configure basic settings for your services gateway.
7.
NOTE: You must manually configure the IP address for the management port you are
using before you save your initial configuration. When you save the configuration for
the first time, you will lose the connection to the services gateway if you have not
manually configured the IP address. If you lose the connection through the management
interface, you must connect through the Console port.
subnetwork other than
192.168.1/24
192.168.1.0/24
192.168.1.1
subnetwork if the