Table of Contents
Advertisement
PowerConnect J-SRX210 Services Gateway Hardware Guide
Understanding Built-In Ethernet Ports
Mapping the Chassis Cluster Ports
92
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Note the following points about the J-SRX210 Services Gateway management port:
The J-SRX210 Services Gateway uses
management ports to perform initial device setup. Before initial configuration, when
the factory default configuration is active, the device attempts to perform
autoinstallation by obtaining a device configuration through all of its connected
interfaces.
The services gateway acts as a DHCP client out of the built-in Ethernet ports. If the
services gateway does not find a DHCP server within a few seconds, the device acts
as a DHCP server and assigns an IP address as 192.168.1.1/24. With the device
temporarily acting as a DHCP server, you can manually configure it with the J-Web
interface.
Any DHCP client host, for example, a PC or laptop computer, directly connected to any
of
or
ge-0/0/1
fe-0/0/2
network.
On the J-SRX210 Services Gateway, the following ports are not user configurable when
the services gateway is operating in chassis cluster mode.
The
fxp0
port is dedicated as the out-of-band management interface for each of the
devices in the chassis cluster setup and the
control port.
Table 36 on page 92 shows the mapping of the chassis cluster ports.
Table 36: Mapping the Chassis Cluster Ports on a J-SRX210 Services
Gateway
FE Ports on J-SRX210 Services Gateway
fe-0/0/6
fe-0/0/7
JUNOS Software automatically creates the fxp0 and fxp1 interfaces on these ports when
the J-SRX210 Services Gateway is operating in chassis cluster mode.
For more information, see the following guides:
JUNOS Software Interfaces and Routing Configuration Guide
and
ge-0/0/1
to
ports receives an address on the 192.168.1.1/24
fe-0/0/7
port is dedicated as the chassis-cluster
fxp1
Management Interface
fxp0 (management port)
fxp1 (control port)
to
as a
fe-0/0/2
fe-0/0/7
Advertisement
Table of Contents
