Connecting The Modem At The J-Srx210 Services Gateway End - Dell PowerConnect J-SRX210 Hardware Manual

Related Topics

Connecting the Modem at the J-SRX210 Services Gateway End

Table 34: Port Settings to Configure the Modem on Services Gateway End
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
Chapter 15: Connecting the J-SRX210 Services Gateway to Management Devices
A second modem connected to a remote management device
The modem connection allows you to remotely perform the same console operations
you can perform locally.
Connecting a J-SRX210 Services Gateway to the CLI Locally on page 85
Performing Initial Software Configuration on the J-SRX210 Services Gateway Using
CLI on page 94
Connecting a J-SRX210 Services Gateway to the J-Web Interface on page 83
J-SRX210 Services Gateway Software Configuration Overview on page 91
J-SRX210 Services Gateway Secure Web Access Overview on page 101
NOTE: These instructions use Hayes-compatible modem commands to configure the
modem. If your modem is not Hayes-compatible, refer to the documentation for your
modem and enter the equivalent modem commands.
To configure the modem on the services gateway end:
Connect the modem to a PC or laptop computer.
1.
Power on the modem.
2.
From the PC or laptop computer, start your asynchronous terminal emulation
3.
application (such as Microsoft Windows HyperTerminal) and select the
to which the modem is connected (for example,
Configure the port settings shown in Table 34 on page 87.
4.
In the HyperTerminal window, enter
5.
For more information on the AT commands, see the JUNOS Software Administration
Guide.
).
COM1
Value
9600
8
None
1
None
.
AT
port
COM
87