Rack Mount - Dell EMC SD-WAN Edge 600 Series Installation Manual

Keyhole-shaped bracket installation
4. Using a torque screwdriver, attach the wall mount brackets to the platform using the four M3 screws included.
5. Anchor the screws into the wall surface.
6. Place the pre-installed platform brackets over the wall-mounted screws. Slide the platform to one side to secure the platform in place.
WARNING: When mounting the Edge 640 or Edge 680 platform to the wall, face the Ethernet ports up towards the
ceiling and the system status LED panel down, facing the floor.

Rack mount

As an option, you can mount the Edge 600 Series platform to a dual rackmount tray. Purchase the dual rackmount tray separately. You
must have a torque screwdriver to complete this installation.
NOTE: When driving the screws into the bracket and platform, verify that you torque to 5 lb-in.
NOTE: When mounting the platform to the wall using the included wall mount brackets, you do not need to remove the
rubber pads from the bottom of the platform.
Edge 600 Series installation 15