Table of Contents
Advertisement
DC power input
The power supply connector consists of three pins: V+, GND, and V– from left to right, respectively. V+ and V– pins provide DC
power input. The DC power input for the EGW-3200 allows a voltage input range from 9 to 36 VDC.
Figure 17. DC power input
Table 10. DC power input pin definitions
Pin
1
2
3
Table 11. Power source rating
Source
DC power source
AC-to-DC adapter (offered separately)
PD power in
The green DC power connector is included in the Accessory Box.
NOTE:
If the connector is damaged or needs replacement, use the DECA MC421-35003Z-1.
See
Attach DC power connector
An AC-to-DC adapter is offered separately. See
CAUTION:
Before providing DC power, ensure the voltage and polarity provided are compatible with the DC
input. Use an approved power source as certified by IEC or UL. Improper input voltage and/or polarity can be
responsible for system damage.
USB ports
The EGW-3200 provides four USB 3.1 Gen1 ports with Type A interface. All USB ports are compatible with SuperSpeed,
high-speed, full-speed, and low-speed USB devices, with support for multiple boot devices, including USB flash, USB external
HDD, USB CD-ROM drivers, and boot priority and boot device configured in BIOS.
Ethernet ports
There are two Ethernet ports on the front panel, and each has its own specification and performance.
LAN 1 is equipped with an Intel i225 LAN chip with integrated MAC/PHY supporting 10BASE-Te, 100BASE-TX, 1000BASE-T and
2500BASE-T, and 802.3 specifications.
LAN 2 is equipped with a Marvell 88E1512 LAN chip with 10/100/1000BASE-T support and IEEE 802.3 compliance.
Signal
V+ (DC_IN)
GND (chassis ground)
V– (DGND)
on page 26 to install the DC power connector to the DC power input.
Attach DC power connector
Voltage
9 to 36 VDC
24 VDC
36 to 57 VDC
on page 26 for installation details.
Current
10.0 A to 2.5 A min.
5.0 A min.
1.6 A to 1.0 A min.
System Layout
17
Advertisement
Table of Contents
