Understanding Built-In Ethernet Ports; Mapping The Chassis Cluster Ports - Dell PowerConnect J-SRX100 Hardware Manual

PowerConnect J-SRX100 Services Gateway Hardware Guide

Understanding Built-In Ethernet Ports

Mapping the Chassis Cluster Ports

72
NOTE: The J-SRX100 Services Gateway that ship with JUNOS Release 10.0
or later are formatted with dual-root partitions from the factory.
For more information on dual-root partitioning, see the Junos OS Administration Guide
for Security Devices.
You configure the services gateway by issuing JUNOS command-line interface (CLI)
commands.
Gather the following information before configuring the device:
Device name to be used on the network
Domain name the device will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Note the following points about the J-SRX100 Services Gateway management ports:
The J-SRX100 Services Gateway uses
perform initial device setup. Before initial configuration, when the factory default
configuration is active, the device attempts to perform autoinstallation by obtaining
a device configuration through all of its connected interfaces.
The services gateway acts as a DHCP client out of the built-in Ethernet ports. If the
services gateway does not find a DHCP server within a few seconds, the device acts
as a DHCP server and assigns an IP address as 192.168.1.1/24. With the device
temporarily acting as a DHCP server, you can manually configure it with the J-Web
interface.
Any DHCP client host, for example, a PC or laptop computer, directly connected to any
of fe-0/0/1 to fe-0/0/7
On the J-SRX100 Services Gateway, the
services gateway is operating in chassis cluster mode.
The port is dedicated as the out-of-band management interface for each of the
fxp0
devices in the chassis cluster setup and the
control port.
Table 25 on page 73 shows the mapping of the chassis cluster ports.
to
fe-0/0/1
ports receives an address on the 192.168.1.1/24 network.
port is not user configurable when the
fxp1
port is dedicated as the chassis-cluster
fxp1
as management ports to
fe-0/0/7