PowerConnect J-SRX100 Services Gateway Hardware Guide
Preparing the J-SRX100 Services Gateway for Desk-Mount Installation
Related
Documentation
Preparing the J-SRX100 Services Gateway for Wall-Mount Installation
38
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
You can mount a J-SRX100 Services Gateway on a desk or other level surface horizontally
or vertically. The four rubber feet attached to the chassis provide stability.
Before mounting a J-SRX100 Services Gateway on a desk or other level surface:
Verify that the site meets the requirements described in "Site Preparation Checklist
for the J-SRX100 Services Gateway" on page 19.
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see "Unpacking the J-SRX100 Services Gateway" on page 33.
If you are mounting the device vertically on the desk, make sure that the following parts
are available in your vertical desk-mounting kit for the J-SRX100 Services Gateway:
Vertical stand
Screws
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Site Preparation Checklist for the J-SRX100 Services Gateway on page 19
Unpacking the J-SRX100 Services Gateway on page 33
Clearance Requirements for Airflow and Hardware Maintenance of the J-SRX100
Services Gateway on page 24
Preparing the J-SRX100 Services Gateway for Rack-Mount Installation on page 37
Preparing the J-SRX100 Services Gateway for Wall-Mount Installation on page 38
You can mount a J-SRX100 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Before mounting a J-SRX100 Services Gateway on a wall:
Verify that the site meets the requirements described in "Site Preparation Checklist
for the J-SRX100 Services Gateway" on page 19.