Installation procedure for 4G expansion
About this task
Installation of the 4G expansion module requires an additional heat sink to ensure performance.
Use the paddle-style antennas that are included with the expansion kit. The following figure shows the dimensions of the
antenna.
NOTE:
Perform this procedure in an electrostatic discharge (ESD) controlled environment.
Figure 11. 4G/5G/LTE antenna (dimensions in mm)
Table 3. Expansion module packing list - 4G
Item
Screw M3 x 6L
Screw M3 x 4L
Standoff H7.8
Standoff H19.5
Bracket
4G M.2
SMA cable
Quantity
Notes
1
Torque required: 4.0 kgf.cm
7
Torque required: 4.0 kgf.cm
1
Torque required: 4.5 kgf.cm
2
Torque required: 4.5 kgf.cm
1
-
1
-
3
Torque required: 8.0 kgf.cm
Installation procedure for 4G expansion module
II
module
11