Dell PowerConnect J-SRX100 Hardware Manual page 93

Chapter 13: Performing Initial Software Configuration on the J-SRX100 Services Gateway
Table 27: Basic Configuration Summary (Management Access)
Field Function
Default Gateway Defines a default gateway through which
to direct packets addressed to networks
not explicitly listed in the routing table.
Loopback Address Defines a reserved IP address that is
always available on the services gateway.
If no address is entered, this address is set
to
127.0.0.1/32
Allow Telnet Allows remote access to the services
Access gateway using Telnet.
Allow JUNOScript Allows JUNOScript to access the services
over Clear-Text gateway using a protocol for sending
Access unencrypted text over a TCP connection.
Allow SSH Access Allows remote access to the services
gateway using SSH.
Table 28: Basic Configuration Summary (Date and Time)
Field Function
Date and Time
Time Zone Identifies the time zone in
which the services gateway is
located.
NTP Servers Specifies an NTP server that
the services gateway can reach
to synchronize the system
time.
Current Synchronizes the system time
System with the NTP server or allows
Time you to manually set the system
time and date.
.
Your Action
From the list, select the appropriate time zone.
Add an IP address by clicking Add and entering
IP address and then clicking OK.
Delete an IP address by clicking it in the box and
then clicking Delete.
Set the time immediately using the NTP server;
select NTP Servers. The services gateway
sends a request to the NTP server and
synchronizes the system time.
NOTE: If you are configuring other settings on
this page, the services gateway also synchronizes
the system time using the NTP server when you
click OK.
Set the time manually by selecting the Manual
button. A window allows you to select the
current date and time from lists.
Your Action
Type a 32-bit IP address in
dotted decimal notation.
Type a 32-bit IP address and
prefix length in dotted decimal
notation.
Enable Telnet access by
selecting the box.
Enable JUNOScript access
over cleartext by selecting the
box.
Enable SSH access by
selecting the box.
79