Preparing The J-Srx100 Services Gateway For Installation; Preparing The J-Srx100 Services Gateway For Rack-Mount Installation - Dell PowerConnect J-SRX100 Hardware Manual

CHAPTER 7
Preparing the J-SRX100 Services Gateway
for Installation

Preparing the J-SRX100 Services Gateway for Rack-Mount Installation

This chapter includes the following sections:
Preparing the J-SRX100 Services Gateway for Rack-Mount Installation on page 37
Preparing the J-SRX100 Services Gateway for Desk-Mount Installation on page 38
Preparing the J-SRX100 Services Gateway for Wall-Mount Installation on page 38
You can mount a J-SRX100 Services Gateway in four-post (telco) racks, enclosed
cabinets, and open-frame racks.
NOTE: The J-SRX100 Services Gateway cannot be center-mounted in racks.
Before mounting the J-SRX100 Services Gateway in a rack:
Verify that the installation site meets the requirements described in "Site Preparation
Checklist for the J-SRX100 Services Gateway" on page 19.
Verify that the racks or cabinets meet the specific requirements described in "J-SRX100
Services Gateway Rack Requirements" on page 23.
Place the rack or cabinet in its permanent location, allowing adequate clearance for
airflow and maintenance, and secure it to the building structure. For more information,
see "Clearance Requirements for Airflow and Hardware Maintenance of the J-SRX100
Services Gateway" on page 24.
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see "Unpacking the J-SRX100 Services Gateway" on page 33.
Verify that you have the following parts available in your rack-mounting kit for the
J-SRX100 Services Gateway:
Rack-mount tray
Screws
37