J-Srx100 Services Gateway Installation Safety Guidelines And Warnings - Dell PowerConnect J-SRX100 Hardware Manual

Related
Documentation

J-SRX100 Services Gateway Installation Safety Guidelines and Warnings

equipment. We recommend that fire suppression equipment be available in the event
of a fire in the vicinity of the equipment and that all local fire, safety, and electrical codes
and ordinances be observed when installing and operating your equipment.
In the event of an electrical hazard or an electrical fire, first turn power off to the equipment
at the source. Then use a Type C fire extinguisher to extinguish the fire. Type C fire
extinguishers, which use noncorrosive fire retardants such as carbon dioxide (CO
Halotron, are most effective for suppressing electrical fires. Type C fire extinguishers
displace the oxygen from the point of combustion to eliminate the fire. For extinguishing
fire on or around equipment that draws air from the environment for cooling, use this
type of inert oxygen displacement extinguisher instead of an extinguisher that leave
residues on equipment.
Do not use multipurpose Type ABC chemical fire extinguishers (dry chemical fire
extinguishers) near the equipment. The primary ingredient in these fire extinguishers is
monoammonium phosphate, which is very sticky and difficult to clean. In addition, in
minute amounts of moisture, monoammonium phosphate can become highly corrosive
and corrodes most metals.
Any equipment in a room in which a chemical fire extinguisher has been discharged is
subject to premature failure and unreliable operation. The equipment is considered to
be irreparably damaged.
NOTE: To keep warranties effective, do not use a dry chemical fire extinguisher
to control a fire at or near a J-SRX Series services gateway. If a dry chemical
fire extinguisher is used, the unit is no longer eligible for coverage under a
service agreement.
We recommend that you dispose of any irreparably damaged equipment in an
environmentally responsible manner.
J-SRX100 Services Gateway General Safety Guidelines and Warnings on page 101
J-SRX100 Services Gateway Installation Safety Guidelines and Warnings on page 105
Installation Instructions Warning
WARNING: Read the installation instructions before you connect the services
gateway to a power source.
Waarschuwing Raadpleeg de installatie-aanwijzingen voordat u het systeem
met de voeding verbindt.
Varoitus Lue asennusohjeet ennen järjestelmän yhdistämistä virtalähteeseen.
Appendix A: Safety and Regulatory Compliance Information
) and
2
105