Error Messages - Epson AcuLaser CX16 User Manual

This message...
SEARCHING
SCANNING
Warming Up
REFRESHING
PLEASE WAIT!

Error Messages

Note:
For details on fax error messages, refer to the Facsimile User's Guide. (AcuLaser CX16NF only)
This message...
ADDRESS IS TOO LONG
CANNOT CONNECT
xxx Server
CANNOT GET IP
xxx Server
CHECK TRAY1 PAPER
1
LOAD PAPER ( xx)
(PRESS START KEY)
Check Print Mode= l
COMMUNICATION ERROR
USB Memory
AcuLaser CX16 Series
means...
The machine is searching data.
The machine is scanning the document.
The machine is warming up or AIDC is
being performed.
The printer is adjusting the toner
distribution.
means...
The e-mail address retrieved
from the LDAP server exceeds
64 characters.
A connection with the
specified server could not be
established.
The IP address of the specified
server could not be obtained
from the DNS server.
Tray1 has run out of paper.
Media has misfed in Tray 1.
A printer error occurred
during printing.
While data was being sent in
Scan mode, the connection to
the USB memory device was
interrupted.
Printer / Copier / Scanner User's Guide
Do this...
No action needed.
Do this...
This machine can handle addresses
containing no more than 64 bytes.
Use a shorter address.
Check the settings specified in the
NETWORK SETTING and E-MAIL
SETTING menus, and then try
sending the data again.
Check the settings specified in the
NETWORK SETTING and E-MAIL
SETTING menus, and then try
sending the data again.
Load media into the tray, and then
press the Start key.
Remove the misfed media.
Press the l key to check the error,
then take the appropriate
measures.
Check the connection to the USB
memory device, and then try
sending the data again.
Troubleshooting 191