Epson AcuLaser CX16 User Manual page 36

REMOTE MONITOR
NETWORK TCP/IP
SETTING
IP ADDR. SETTING
DNS CONFIG.
*1
DHCP
*1
BOOTP
ARP/PING
*1
HTTP
AcuLaser CX16 Series
Setting
Select whether or not setting remote monitor.
If ON is selected, technical support can access the menu mode.
If OFF is selected, technical support cannot access the menu
mode.
Note:
This setting is for technical support uses. Change the setting
only when it is necessary.
Setting
Select the setting for connecting to this machine through a
network.
*1 Setting
Set the IP address of this machine on the network.
If AUTO is selected, the IP address will be assigned automati-
cally.
If SPECIFY is selected, manually specify settings for IP AD-
DRESS, SUBNET MASK and GATEWAY.
*1 Setting
Set whether or not the DNS server setting is to be specified.
If ENABLE is selected, specify DNS server addresses (up to
three addresses).
Setting
If there is a DHCP server on the network, specify whether the IP
address and other network information is automatically as-
signed by the DHCP server.
Setting
If there is a BOOTP server on the network, specify whether the
IP address and other network information is automatically
assigned by the BOOTP server.
*1 Setting
Select whether or not the ARP/PING command is used when
the IP address is assigned.
Setting
Select whether or not to enable HTTP.
Printer / Copier / Scanner User's Guide
OFF / ON
DISABLE / ENABLE
AUTO / SPECIFY
DISABLE / ENABLE
DISABLE / ENABLE
DISABLE / ENABLE
DISABLE / ENABLE
DISABLE / ENABLE
Control Panel and Configuration Menu 36