Epson AcuLaser CX16 User Manual page 53

Envelope
Print on the front (address) side only. Some parts of the envelope consist of three layers of paper—the
front, back, and flap. Anything printed in these layered regions may be lost or faded.
You can print continuously with envelope. However, this could affect the media feed, depending on
the media quality and printing environment. If problems occur, stop the continuous printing and
print one sheet at a time.
Capacity
Orientation
Driver Media
Type
*1
Duplexing
*1
Only for AcuLaser CX16NF
Use envelopes that are
❏ Envelope C6 or Envelope DL (Other envelope sizes are not supported.)
❏ Common office envelopes approved for laser printing with diagonal joints, sharp folds and edges,
and ordinary gummed flaps
Note:
Because the envelopes pass through heated rollers, the gummed area on the flaps may seal. Using
envelopes with emulsion-based glue avoids this problem.
❏ Approved for laser printing
❏ Dry
DO NOT use envelopes that have
❏ Sticky flaps
❏ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for sealing
❏ Transparent windows
❏ Too rough of a surface
Tray 1 Up to 10 sheets, depending on their thickness
*1 Not supported
Tray 2
Face up
Envelope
Not supported
AcuLaser CX16 Series Printer / Copier / Scanner User's Guide
Media Handling 53