Epson AcuLaser CX16 User Manual page 194

This message...
NOT REGISTERED
OUTPUT TRAY FULL
REMOVE PAPER
OVER SEARCH TIME
Paper Empty
2
LOAD PAPER ( xx)
PAPER SIZE ERROR
RESET PAPER (xxx)
PC CONNECTION FAILED
Process Caution-IDC
PROCESS ERROR-xxx
CLEAR BY COVER
REMOVE ORIGINAL
IN ADF
RESULTS ARE OVER xxx
AcuLaser CX16 Series
means...
No speed dial destination or
group dial destination is
registered.
Otherwise, no destination has
been registered with the
specified speed dial or group
dial number.
The output tray is full of paper.
Communication with the
LDAP server has timed out.
Tray 2 has run out of paper.
The size of paper being
printed on is different from the
size of paper specified in the
printer driver.
While data was being sent in
Scan mode, the connection to
the computer was
interrupted.
A process error occurred in the
machine.
The document is loaded in the
ADF while a function is set that
requires scanning from the
original glass.
The LDAP search results
exceed the maximum
specified with MAX.SEARCH
RESULTS in the LDAP SETTING
menu.
Printer / Copier / Scanner User's Guide
Do this...
Directly type in the destination
address for the scan data, or
register a speed dial destination or
group dial destination and try
specifying the destination address
again.
Remove all paper from the output
tray.
Establish a connection with the
LDAP server again.
Load media into the tray.
Press the Start key to cancel the
caution.
To print on paper of the size
specified in the printer driver, load
paper of the correct size into the
specified tray, and then try
performing the print job again.
Check the connection with the
computer and the scanner driver
status, and then try sending the
data again.
Open and close the scanner unit.
Place the document on the original
glass.
Change the maximum setting, or
change the search conditions (for
example, increase the length of the
keyword), and then try performing
the LDAP search again.
Troubleshooting 194