Removing the blade server bezel assembly
To install certain options, you must first remove the blade server bezel assembly.
Complete the following steps to remove the blade server bezel assembly:
1. Review the safety information beginning on page 109 and "Installation
2. Open the blade server cover (see "Opening the blade server cover" on page 40
3. Press the bezel-assembly release, and rotate the bezel assembly away from the
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
42
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
guidelines" on page 33.
for instructions), and lift it off the blade server.
blade server chassis; then, unhook the tabs on the bottom of the bezel from the
holes on the server chassis, and remove the bezel.
Bezel-assembly release
Control-panel
connector
Control-panel
cable
Bezel-assembly release