Removing the blade server bezel assembly
To install certain options you must first remove the blade server bezel assembly.
The following illustration shows how to remove the bezel assembly from a blade
server.
Complete the following steps to remove the blade server bezel assembly:
1. Review the information in "Safety" beginning on page vii and "Installation
2. Open the blade server cover.
3. Press the bezel-assembly release and pull the bezel assembly away from the
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Installing IDE hard disk drives
Your blade server has two connectors on the system board for installing optional
2.5-inch IDE hard disk drives. Each IDE connector is on a separate bus. Some
models come with at least one IDE hard disk drive already installed.
Two IDE drives can be used to implement and manage RAID level-1 under both the
Linux and Microsoft Windows 2000 operating systems.
Attention:
unit for more than one minute without either a blade server, expansion unit, or filler
blade installed in each blade bay.
22
BladeCenter HS20 Type 8832: Installation and User's Guide
Bezel-assembly
release
Control panel
connector
guidelines" on page 19.
blade server approximately 1.2 cm (0.5 inch).
To maintain proper system cooling, do not operate the BladeCenter
Bezel-assembly
release
Control-panel
cable