IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual page 74

The following illustration shows how to close the blade server cover.
Cover
pins
Air baffle
Complete the following steps to close the blade server cover:
1. Review the safety information beginning on page 109 and "Installation
2. If you removed the blade bezel assembly, replace it now. See "Installing the
3. Before closing the cover, check that all components are installed and seated
4. Make sure that the air baffle covering microprocessor 1 and microprocessor 4 is
5. Lower the cover so that the slots at the rear slide down onto the pins at the rear
6. Pivot the cover to the closed position as shown in the illustration, until it clicks
64
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
guidelines" on page 33.
blade server bezel assembly" on page 62 for instructions.
correctly and that you have not left loose tools or parts inside the blade server.
Attention: To help ensure proper cooling and system reliability the air baffle
must be correctly positioned and fully seated.
positioned and pushed down so that both heat sink captive mounting screws are
through the holes in the air baffle.
Air baffle
of the blade server, as shown in the illustration.
into place.
Blade cover
Microprocessor 1 and 4
heat sink captive mounting screws