Features And Specifications; Bladecenter Hs40 Specifications For Non-Nebs/Etsi Environments - IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual

Features and specifications

This section provides a summary of the features and specifications of your blade
server. Use the Configuration/Setup Utility program in your server to determine the
specific type of microprocessor that is in the blade server.

BladeCenter HS40 specifications for non-NEBS/ETSI environments

The following table provides a summary of the features and specifications of your
BladeCenter HS40 Type 8839 blade server operating in a non-NEBS/ETSI
environment.
Note: Power, cooling, removable-media drives, external ports, and advanced
Microprocessor:
Supports up to 4 microprocessors
v Intel Xeon 2.0 GHz or faster
v L2 and L3 caches, size dependant
on microprocessor
Memory:
v Eight double data rate (DDR)
PC2100 184-pin DIMM sockets
v Minimum: 512 MB
1
v Maximum: 16 GB
v Type: 2-way interleaved, DDR,
PC2100, ECC SDRAM registered
x4 (Chipkill) dual inline memory
modules (DIMMs) only
v Supports 256 MB, 512 MB, 1 GB,
and 2 GB DIMMs
v Hot Spare memory
Expansion:
Two I/O expansion card
connectors
Drives:
Support for up to two Ultra320
SCSI hot-swap hard disk drives
available in an optional SCSI
storage expansion unit
Notes:
1. You might have to enable large-memory support for your operating system to
2. The operating system in the blade server must provide USB support for the
4
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide
system management are provided by the IBM Eserver BladeCenter Type
8677 and IBM Eserver BladeCenter T Types 8720 and 8730.
Size:
v Height: 24.5 cm (9.7 inches)
v Depth: 44.6 cm (17.6 inches)
v Width: 5.9 cm (2.32 inches)
v Maximum weight: 7.0 kg (15.4 lb)
Integrated functions:
v Four Gigabit Ethernet controllers
v ATI Radeon 7000 video controller
v Light path diagnostics
v Local service processor
v IDE hard disk drive controller (the
IDE controller is reserved for
future use and is not available for
this server type)
v RS-485 interface for
communication with the
management module
v Integrated Baseboard
Management Controller
v Universal Serial Bus (USB) v1.1
for communication with keyboard,
mouse, diskette drive, and
CD-ROM drive
v Serial over LAN (SOL)
management interface
Electrical input:
Input power: 400 W, maximum
access all of the memory that is installed in your blade server. See the
documentation for your operating system for information.
blade server to recognize and use the keyboard, mouse, CD-ROM drive, and
diskette drive. The BladeCenter unit uses USB for internal communications with
these devices.
Predictive Failure Analysis (PFA)
alerts:
v Microprocessor
v Memory
v Hard disk drives
Environment:
v Air temperature:
– Blade server on: 10° to 35°C (50°
– Blade server on: 10° to 32°C (50°
– Blade server off: -40° to 60°C
v Humidity:
– Blade server on: 8% to 80%
– Blade server off: 5% to 80%
2
to 95°F). Altitude: 0 to 914 m
(2998.69 ft)
to 95°F). Altitude: 914 m to 2134
m (2998.69 ft to 7000 ft)
(-40° to 140° F)